Light Fixture for Brentwood homes
Brentwood is large-lot estate territory with mid-century moderns, traditional homes, and contemporary builds. Many homes have multiple chandelier-grade fixtures (entry, dining, primary living, primary bedroom) and dozens of recessed cans across the floor plan. Whole-home Lutron RA2 or Crestron lighting integration is the default expectation in homes built or remodeled after 2010. Multi-fixture visits with cable concealment and scene programming are the typical scope of work.
Pricing for a single 25–40 pound chandelier with brace box and grounding runs $260–420. Recessed can installation runs $180–260 first can / $120–180 each additional with attic access. Whole-home Lutron RA2 retrofit (15–25 switches across multiple rooms) runs $2,000–4,500 including programming. Multi-fixture visits with 3–5 chandeliers and supporting flush-mounts run $1,200–2,800 in a single half-day to full-day window. Many Brentwood homes have stone or wood-paneled accent walls that need careful planning around for sconce placement.
About light fixture
Light fixture installation is the process of removing an old ceiling or wall fixture, mounting a new one to a fixture-rated electrical box, and wiring it through the existing circuit so it switches cleanly from your wall control. The work itself takes 30–90 minutes for a standard like-for-like swap, but the details that make a job last decades — the right box for the weight of the fixture, the ground wire correctly bonded, the dimmer matched to the bulb technology, the canopy sitting flush against the ceiling — are where most DIY installs and rushed handyman jobs fall apart.
Read the full Light Fixture guide →Pricing in Brentwood
$100–280 typical range for Brentwood jobs.
Standard fixture swap in Los Angeles — replacing an existing flush-mount or pendant with a new one, same wiring, standard 8-foot ceiling — runs $80–150 for the labor. This covers turning off the breaker, removing the old fixture, mounting the new one, wiring it up, and installing the canopy. Most jobs in this range are 45–60 minutes door-to-door.
Brentwood light fixture FAQ
Can the pro install fixtures in 6 rooms in one visit?+
Yes for a multi-fixture estate visit. Plan a full-day window for 5–7 fixtures with cable concealment. Larger scopes (whole-home lighting overhauls) are scheduled across 2–3 days for clean execution.
Will Lutron RA2 control all my new fixtures?+
Yes if every fixture is on a circuit that routes through the RA2 processor. The pro will verify circuit routing during install and coordinate scene programming with the AV programmer. RA2 vs Caseta — RA2 scales to 100+ devices, Caseta tops out at 75.
Can I get fixtures installed during a remodel?+
Yes. The pro coordinates with the GC for timing — typically fixtures go in after drywall and paint are complete, before the final cleanup. Mention the remodel schedule when you book so the pro can sequence around other trades.
Are vaulted ceilings extra?+
Yes. Anything above 12 feet needs lift equipment and adds 30–60 minutes per fixture. $100–250 surcharge per vault-mounted fixture depending on height and access.
Every light fixture pro verifies their identity
Government ID + selfie liveness check via Persona — required for every listing. Pros may earn additional Insurance Verified and License Verified badges by uploading documents we check. Read our standards →