Door Installation for Culver City homes
Culver City is a mix of 1920s-50s bungalows and modern townhomes, with a heavy tech-industry homeowner base that drives a lot of renovation activity. Door work here is split between two patterns: bungalow owners doing slow remodels who finally get around to the doors after kitchen and floors are done, and townhome owners dealing with builder-grade hollow-core slabs that they want to upgrade to solid-core. Both are straightforward — slab swaps for interior at $150 to $280 per door, multi-door bundles drop the per-door cost.
The bungalow side has occasional 1920s original doors worth restoring rather than replacing — the same Douglas fir five-panel pattern that shows up across all Eastside and Westside bungalow neighborhoods. The townhome side is straightforward stock-door work, with Masonite solid-core upgrades being the most common interior pick. For exterior front doors, Therma-Tru fiberglass is the right call for most Culver City homes — UV exposure on the south-facing fronts of many homes here will burn through cheaper exterior doors within a few years.
About door installation
Door installation is the process of fitting a new door — interior, exterior, sliding, or barn — into an opening so that it closes flush, latches without forcing, swings without dragging, and seals against drafts, sound, or weather. The work covers measuring the rough opening, choosing between a pre-hung unit (door already mounted in its frame) and a slab door (door only, reusing the existing frame), shimming and leveling the frame, hanging the hinges, drilling for the latch and strike plate, and finally adjusting the hardware so the door operates smoothly. A clean install ends with a door that latches with a soft click rather than needing a shoulder push, and a gap line around the perimeter that stays consistent from top to bottom.
Read the full Door Installation guide →Pricing in Culver City
$180–650 typical range for Culver City jobs.
Interior pre-hung door installation in Los Angeles runs $200–380 per door for labor. This covers fitting the unit into the rough opening, shimming plumb and level, securing the frame, hanging the door, and basic latch and strike plate alignment. Hardware (knob or lever set) is usually not included in the labor quote and runs $25–80 retail at Home Depot or $40–150 for upgraded Schlage / Kwikset finishes. Trim work — replacing the casing around the new frame — is sometimes included and sometimes a separate line item, so confirm.
Culver City door installation FAQ
My Culver City townhome has builder-grade hollow-core doors — what's the upgrade cost?+
Slab swap to Masonite solid-core runs $150 to $280 per door in labor, plus $80 to $200 per solid-core door at retail. Five-door bundle in one visit usually $750 to $1,400 in labor. Solid-core makes a meaningful difference in sound transmission between bedrooms — particularly noticeable in townhomes with shared walls.
I'm in a 1920s Culver City bungalow with original doors — restore or replace?+
Same answer as Echo Park, Highland Park, and Eagle Rock. Restore if the wood is solid — original Douglas fir panel doors are worth keeping. A handyman can rehang and refresh for $200 to $350 per door. Replace only the ones with structural damage.
Does my Culver City HOA control the front door?+
If you are in a townhome with a shared exterior, often yes — HOA may require an approved brand and finish. If you are in a freestanding bungalow, no. Read your CC&Rs first. For approved replacements, Therma-Tru fiberglass is on most HOA approved lists for its appearance and durability.
Every door installation pro verifies their identity
Government ID + selfie liveness check via Persona — required for every listing. Pros may earn additional Insurance Verified and License Verified badges by uploading documents we check. Read our standards →