Door Installation for Mid-Wilshire homes
Mid-Wilshire spans pre-war apartment buildings near Larchmont, single-family homes in the Hancock Park edges, and modern mid-rise condos along the Wilshire corridor, and door work splits along those lines. Pre-war apartments often have original 1930s wood doors with a brass kickplate and a transom above — landlords typically replace the unit door only when it has finally given up, and they want a match for the building's look rather than a modern white slab. Tenants are usually not allowed to swap doors without management approval. Single-family home doors in the Larchmont and Hancock Park areas of Mid-Wilshire skew toward Tudor and Spanish-revival styles, where matching the original look matters and a Masonite stock door from Home Depot will visibly clash.
Modern mid-rise condos along Wilshire have their own pattern: standardized hollow-core slab interior doors that came with the building, a steel exterior unit door controlled by HOA, and the question is whether you can change anything without permission. Almost always you can change interior doors freely; the front unit door is HOA-controlled and may require a brand-and-finish match. Confirm with your building manager before booking.
About door installation
Door installation is the process of fitting a new door — interior, exterior, sliding, or barn — into an opening so that it closes flush, latches without forcing, swings without dragging, and seals against drafts, sound, or weather. The work covers measuring the rough opening, choosing between a pre-hung unit (door already mounted in its frame) and a slab door (door only, reusing the existing frame), shimming and leveling the frame, hanging the hinges, drilling for the latch and strike plate, and finally adjusting the hardware so the door operates smoothly. A clean install ends with a door that latches with a soft click rather than needing a shoulder push, and a gap line around the perimeter that stays consistent from top to bottom.
Read the full Door Installation guide →Pricing in Mid-Wilshire
$180–650 typical range for Mid-Wilshire jobs.
Interior pre-hung door installation in Los Angeles runs $200–380 per door for labor. This covers fitting the unit into the rough opening, shimming plumb and level, securing the frame, hanging the door, and basic latch and strike plate alignment. Hardware (knob or lever set) is usually not included in the labor quote and runs $25–80 retail at Home Depot or $40–150 for upgraded Schlage / Kwikset finishes. Trim work — replacing the casing around the new frame — is sometimes included and sometimes a separate line item, so confirm.
Mid-Wilshire door installation FAQ
I rent a pre-war Mid-Wilshire apartment and the door is in bad shape — can I have it replaced?+
Talk to your building manager first. Most pre-war Mid-Wilshire apartment buildings retain the original door style as part of the building's character, and management handles replacements rather than tenants. If approval is given, the work is usually done by the building's preferred contractor, not a handyman you book yourself.
I own a Hancock Park-edge home and want to keep the Tudor look — can I get an exterior door that matches?+
Yes. Therma-Tru and Pella both make fiberglass exterior doors in wood-grain finishes that match Tudor and Spanish-revival styles, with the heat resistance and low maintenance of fiberglass. Custom-cut surcharge of $80 to $150 applies if your opening is non-standard, which is common on these older homes. Total install with door usually runs $1,500 to $2,500.
I'm in a Wilshire-corridor condo — can I swap interior doors freely?+
Almost always yes for interior doors, no for the unit's exterior front door without HOA review. Read the CC&Rs first. Standard hollow-core slab swaps in modern condos run $150 to $280 per door, freight elevator scheduling is usually required for door delivery — confirm with your building's loading dock policy before delivery.
Are barn doors allowed in Mid-Wilshire condos?+
Almost always yes for interior use — barn doors are a popular space-saver in mid-rise condo bedrooms and bathrooms. The install depends on whether the wall above the opening has a strong enough header to anchor the track. A pro will check before quoting; if the header is weak, framing reinforcement adds time and cost.
Every door installation pro verifies their identity
Government ID + selfie liveness check via Persona — required for every listing. Pros may earn additional Insurance Verified and License Verified badges by uploading documents we check. Read our standards →