TV Mounting for Silver Lake homes
Most homes in Silver Lake were built between 1920 and 1945, which means lath-and-plaster walls behind the drywall paint job. That changes everything about how a TV gets mounted. Plaster cracks if you drive a screw into it without a pilot hole, and the wood lath strips behind the plaster are narrower than modern studs, so a generic stud finder will mislead you. A pro who works Silver Lake regularly will tap-test the wall, locate the actual lath, drill pilot holes at the right diameter, and use longer-shank toggle bolts rated for plaster — not the plastic anchors that come in the bracket box. Skipping any of those steps usually ends with a hairline crack across the dining room wall a few months later.
For a standard 55–65 inch TV mount on Silver Lake plaster, expect $160–220 — about $30–40 above the LA flat-drywall rate because of the extra prep time and specialty anchors. Mid-century homes on the hill side of the reservoir sometimes have post-and-beam construction with exposed wood, which is actually easier to mount onto. Tell your pro the year your home was built when you book — it tells them which wall system to plan for.
About tv mounting
TV mounting is the process of securely attaching a flat-screen television to a wall, ceiling, or fireplace using a manufacturer-rated bracket. A proper mount distributes the TV's weight across studs or solid masonry, hides cables for a clean finish, and angles the screen for the room's seating layout. The work itself takes 60–120 minutes for a standard installation, but doing it right requires the correct bracket for your TV size, the right anchors for your wall material, and care to avoid damaging studs, electrical lines, or ductwork behind the drywall.
Read the full TV Mounting guide →Pricing in Silver Lake
$120–280 typical range for Silver Lake jobs.
Standard TV mount on drywall in Los Angeles runs $120–180 for the labor alone. This covers a flat or tilting bracket installation, leveling, and basic cable management down the back of the TV (not in-wall). Most jobs in this range take 60–90 minutes.
Silver Lake tv mounting FAQ
My Silver Lake home is from the 1920s — can the wall handle a 65-inch TV?+
Yes, with the right anchors. Lath-and-plaster walls hold weight fine when the bracket is anchored into the wood lath strips with toggle bolts rated for the TV's weight. The risk is cosmetic cracking from improper drilling, not structural failure. A pro who knows older Eastside homes will pre-drill correctly.
Will mounting crack my plaster?+
Not if it's done right. Pilot holes drilled slowly with a sharp bit, the right anchor type for plaster, and steady pressure on the bracket prevent cracks. A rushed job with the wrong drill speed or a hammer-action setting will crack plaster every time.
Can the pro hide cables in a plaster wall?+
In-wall cable concealment in lath-and-plaster is more involved than in modern drywall — the cavity behind the lath is smaller and the access points need to be cut carefully to patch cleanly afterward. Add $40–80 over the standard concealment quote, and budget extra time.
Are there any Silver Lake homes I should not mount on?+
Original 1920s homes with crumbling plaster (visible cracks, soft spots) should be assessed before drilling. The pro will tap and inspect; if the plaster is failing in that area, a stand or a different wall is the safer call.
Every tv mounting pro verifies their identity
Government ID + selfie liveness check via Persona — required for every listing. Pros may earn additional Insurance Verified and License Verified badges by uploading documents we check. Read our standards →